**broken link removed**
http://earthground.8m.com/rss(1)(1)(1).htm
Does anyone have a clue to modify these circuits for remote control, is it possible to use a PIC16F84 to replace the microphone
or does anyone know how to make an even easier circuit for control of 2 devices (it may not contain transmitter or receiver ic`s because i cant get them here)
The circuits which you have shown does not contain any TX RX ICs. The IC shown in the receiver circuit is a general purpose audio amplifer chip LM386 which is available easily.
To convert these circuits for remote control all you have to do is construct a monostable filp-flop using IC 555 (search google for schematic)and connect it in place of microphone. Now on the receiver end connect a bistable flip-flop which will toggle on reception of every pulse from the transmitter. The monostable on the transmitter side is not very necessary but it is just to give out a sharp pulse which can also be done by rapidly pressing and releasing a push-button switch.
in reply to pilot:
i`m trying to make my bedroom automated, i now control it by voice but i want to make an rf remote control, so if i get home i want to turn on my computer and light.