A buddy of mine got an RC plane for free, but it has no electronics with it. No motor, no servos, no transmitter/receiver, etc. So, its a project of ours to get this thing flying. Any tips on ways to source some cheap parts would be highly appreciated. Plan on going with an electric motor, not glow.
The plane is a Hangar 9 Twist 3D. Here is the only video on YouTube of one of these powered by an electric motor:
YouTube - Radio Control Twist 3D electric
A typical motor (equivalent to 40 - 60 size glow engine) would operate at between 14V and 28V, 40A continuous with up to 60A "burst". Just to get this thing airborne, I dont necessarily need specs that high. So any idea on where to salvage an appropriate motor would be greatly appreciated (drill? car starter? etc.).
A 60A ESC (electronic speed controller) can be had for about $20 plus shipping, not too bad, but again, if money can be saved here, why not.
Well, the other main components are servos, and the controller. Controllers tend to be very pricey, often $200 or much more. So any ideas on that would be great. Servos too, a whole set of them can cost quite a bit so if I can just use some generic parts that would be good.
Thanks!
-Chris P