mramos1 Active Member May 30, 2007 #1 My kids have a 23 or 25" RCA type. Low cost unit. It stopped showing color. All is in black and white. The menus and the channel number in the corner are all in color, so I guess they are added in. I am using CATV input. So the problem I am guess could be in that module there? I know a few of you guess are master TV guys. Thanks. I can get the model number if needed. I would also say it is maybe 5-7 years old.
My kids have a 23 or 25" RCA type. Low cost unit. It stopped showing color. All is in black and white. The menus and the channel number in the corner are all in color, so I guess they are added in. I am using CATV input. So the problem I am guess could be in that module there? I know a few of you guess are master TV guys. Thanks. I can get the model number if needed. I would also say it is maybe 5-7 years old.
Sceadwian Banned May 30, 2007 #2 Perhaps the colour burst crystal is bad? It's dirt cheap to replace even if it's still okay.
zevon8 New Member May 31, 2007 #4 There was an entire series of RCA chassis that had soldering issues. Caused a myriad of problems. See if yours falls into the number range: https://www.repairfaq.org/sam/rcatune.htm
There was an entire series of RCA chassis that had soldering issues. Caused a myriad of problems. See if yours falls into the number range: https://www.repairfaq.org/sam/rcatune.htm
mramos1 Active Member May 31, 2007 #5 Thanks for the ideas. Color burst should not be hard to find and I have some real old one somewhere.. Will check the RCA repair list as well. And I did check color control. Tried changing the presets. It is something actually broken.
Thanks for the ideas. Color burst should not be hard to find and I have some real old one somewhere.. Will check the RCA repair list as well. And I did check color control. Tried changing the presets. It is something actually broken.
D devenfore New Member May 31, 2007 #6 (Maybe I read the question wrong, but...) Does the TV pick up over-the-air signals in color or black and white? Are you using component cables to route the video signal to the box? Could just be a bad cable or connection. Just thought I would state the simple. Hope it helps.
(Maybe I read the question wrong, but...) Does the TV pick up over-the-air signals in color or black and white? Are you using component cables to route the video signal to the box? Could just be a bad cable or connection. Just thought I would state the simple. Hope it helps.