Samsung C21RJAN/BOL ceramic hob

[starLED]

I have a 15-year old ceramic hob Samsung C21RJAN/BOL

Top circle (I don't know what you call it ) is not turning on when I press the sensor button.
Buttons are working and I can select heating level with +/- and it shows numbers for the circle.
I took it to the local repair shop, and they only said it was electronics and not the heater element.
I am not sure that they have done proper job and tested it correctly, so I would like to try see for myself if I can repair it.
I have found images of the PCB on the web:

I can see that there are not many components, only chip and on other side few dozen components.

Is this worth a try to repair?
Does anyone have a clue what a problem can be, what to search for?

Thank you.

 

[Diver300]

That is not an induction hob. It's a ceramic hob so the heating elements are powered from directly from the mains at 220 V 50 Hz.

The control board consists of a low-power switch mode power supply on the left, a microprocessor on the bottom and the three relays on the right (although there is space for a forth). Under each relay there is a SOT23 transistor that powers the relay coil and is controlled by the microcontroller, presumably. The level of heating is set by turning the heating on and off every few seconds.

The first thing to check is if the relays are working. I've repaired appliances before now by just replacing relays like that.

 

[starLED]

Yes, it's a ceramic hob, I didn't know the right translation for it, sorry, my english bad .

OK, I will check the relays.
Will post images next days.

 

[Diver300]

My only other advice would be to buy an induction hob, as they are so much nicer to use than ceramic hobs.

I replaced a ceramic hob with an induction hob and it was really easy to swap them over. That was a 4-ring hob, but there are plenty of 2-ring hobs available.

 

[starLED]

I actually have bought exactly the same ceramic hob, and I am very satisfied with it.
But I would be happy if I fix this one, if possible.