Hi All;
i have a servo motor and going to control it using Microcontroller pic , but i liked to try it at first so i connect it's vcc to 5volts .but i didn't use it's signal at all
then i found that my motor is moving i think to it's initial position and then stoped there ..... and it seems it's trying to continue so it shakes
why that happened? and is it normal
i have a servo motor and going to control it using Microcontroller pic , but i liked to try it at first so i connect it's vcc to 5volts .but i didn't use it's signal at all
then i found that my motor is moving i think to it's initial position and then stoped there ..... and it seems it's trying to continue so it shakes
why that happened? and is it normal