bananasiong
New Member
hi all,
it's me again.. i've a problem of the torque of the stepper motor with the circuit as shown below:
:cry:
previously, i thought that the torque is high enough.. but... when the wheel is conected (i used a modified custer wheel), i found that the torque is not high enough to drive it.
i'm using a uni polar stepper motor, 2 center tapped. drive with around 9V using battery.
can anyone help me with this?? i will appreciate it.. thanks a lot.. :wink:
it's me again.. i've a problem of the torque of the stepper motor with the circuit as shown below:
:cry:
previously, i thought that the torque is high enough.. but... when the wheel is conected (i used a modified custer wheel), i found that the torque is not high enough to drive it.
i'm using a uni polar stepper motor, 2 center tapped. drive with around 9V using battery.
can anyone help me with this?? i will appreciate it.. thanks a lot.. :wink: