A noise generator might be a useful addition to my synth, for wind sounds and such. resonant filter, whooooosh, :lol:
I should try the circuit out, in use but without the element, on breadboard. Then, just put the volume on the mixer right up, and pop different ones in. I bought mine in 2 batches, and will order some more along with the parts, so I have a few to choose from.
I will be trying to build this on a piece of stripboard just 6 tracks accross, with a maximum component height of just a few mm, so that it will slide into the tube for the mic. I think its possible, I have at least 13cm length to use. Whilst i'm asking, it says that the element should be connected with shield cable. Now, if this goes to plan, the element will be less than 1 inch from the circuit, so I doubt this is nessasary. However, the mic will be encased in a metal tube, would it be sensible to ground that tube, effectively shielding the whole circuit, or would that mean that the mic will make noise when I hold it (though it could be in a stand anyhow)?