Ok...
Code Compiles and Runs Ok...
But...
When I press the letter J to run reset ()... I'm not seeing the port pin transmitting any data whilst looking on the scope...
I presume I should see port RC0 going "Hi - Low" as the data is transmitted...
I'm attaching the code as it stands so that perhaps you can advise me further as to how to progress...
Code Compiles and Runs Ok...
But...
When I press the letter J to run reset ()... I'm not seeing the port pin transmitting any data whilst looking on the scope...
I presume I should see port RC0 going "Hi - Low" as the data is transmitted...
I'm attaching the code as it stands so that perhaps you can advise me further as to how to progress...