wijnendael
New Member
Hi, can anyone give me a clue how the following is obtained.
I have built myself a rudder indicator for my boat that uses a 10K pot as a divider to give me the +/- indication of port and starboard postion on leds. I have to manually trim the pots to set the system up but have recently purchased a piece of kit that will do this automatically by setting the position and then pressing a button. By doing this in the centre and the port and startboard position the unit is set. How do they do this and is it possible to make my circuit do this so it is easier to recalibrate when required. Any information would be greatly appreciated so that i can look into it further.
I have built myself a rudder indicator for my boat that uses a 10K pot as a divider to give me the +/- indication of port and starboard postion on leds. I have to manually trim the pots to set the system up but have recently purchased a piece of kit that will do this automatically by setting the position and then pressing a button. By doing this in the centre and the port and startboard position the unit is set. How do they do this and is it possible to make my circuit do this so it is easier to recalibrate when required. Any information would be greatly appreciated so that i can look into it further.