I have a 4 port servo controller, two ports are being used by servos and I need the third one to drive a relay.
The servos work with a Pulse Modulated Signal, so I don't know if the relay will work with it.
I was thinking of using a capacitor to make the signal always-on when the pulses are going and turn of if there are none.
I'm not very good with electronics, so I don't really know where to put what and if it will work.
Thanks,
Alvaro
The servos work with a Pulse Modulated Signal, so I don't know if the relay will work with it.
I was thinking of using a capacitor to make the signal always-on when the pulses are going and turn of if there are none.
I'm not very good with electronics, so I don't really know where to put what and if it will work.
Thanks,
Alvaro