Schematic
Hi Again,
The schematic is made using Orcad.
That means if the net has the same name it is consider connected.
So if you will look at top right and top left - you will see aditional 2 fets at each of the sides.
About timing you are correct, it depends also about PWM frequency, and my frequency is a little problematic in this case (14Khz), charge is about 5 Thao, wich is 5*R*c, that gives me maximum freqeuncy of 6Khz, otherwise Mosfet as you said will work on linear mode, and not saturation.
I Also considering to work only with N-chanel H bridge, with DC to DC that will make higher than 36V in order to turn on The NMOSFET that is connected to 36V, did any one try this before?
Is any one has any circuit that can drive out about 150A ??
Thanks for your help,
Roee.