I'm looking at making something similar (to a degree) to this: Equinox Clock | BramKnaapen.com
Does anyone know how I could go about making something similar to the casing that this project was housed in? The designer only had this to say about the body: "The body was laser cut, assembled and spray painted, the plexiglass blocks were sandblasted."
Does anyone know what machine is used to laser cut plexiglass like that? Is it something I could buy and put in my garage? Alternatively, is there any company would make one-off cuts like this?
I realize this isn't exactly an electronics project, but I figure someone out there has to have run into needing a custom fitting case to house their electronics project... Any advice?
Does anyone know how I could go about making something similar to the casing that this project was housed in? The designer only had this to say about the body: "The body was laser cut, assembled and spray painted, the plexiglass blocks were sandblasted."
Does anyone know what machine is used to laser cut plexiglass like that? Is it something I could buy and put in my garage? Alternatively, is there any company would make one-off cuts like this?
I realize this isn't exactly an electronics project, but I figure someone out there has to have run into needing a custom fitting case to house their electronics project... Any advice?