Does anyone know how I could go about making something similar to the casing that this project was housed in? The designer only had this to say about the body: "The body was laser cut, assembled and spray painted, the plexiglass blocks were sandblasted."
Does anyone know what machine is used to laser cut plexiglass like that? Is it something I could buy and put in my garage? Alternatively, is there any company would make one-off cuts like this?
I realize this isn't exactly an electronics project, but I figure someone out there has to have run into needing a custom fitting case to house their electronics project... Any advice?
Yes - if you have the money; IIRC, on the very low end (discounting homebrew, of course) they are down to around $2000.00 (US) - and they quickly rise in price from there...
Alternatively, is there any company would make one-off cuts like this?