Need to replace an old power supply

Status
Not open for further replies.
F

Flyback

Well-Known Member
Hi,

Need to replace an offline 240VAC power supply that had outputs +13.5V, 6A and -13.5V, 1A.
Size is 140mm x 230mm x 55mm. In metal case with vent holes for fans.

Do you off the top of your head know of any quick, cheap off the shelf way of doing this?
 
I would take this to the leading manufacturers and post the requirements, along with
datasheet for old supply. That way they can confirm it meets the same standards, as
well as the application HW.


Regards, Dana.
 
Thanks, i think two 15v open frame SMPS's which can be trimmed down to 13.5V woudl do the job...then we can knock them into a case and voila.

Thinking about one of these for the 13.5V at 6A:
LM25-23B15

and one of these for the -13.5V at 1.5A:
LCS100US15

in a metal enclosure, and add some fans in there.

And add some diodes across each output, this will give 13.5v-0-(-13.5v)


And even though its >75W, we will not have to worry about PFC?...because each PSU passes regulations on their own......so even though we have mounted them in a single box, the overall PFC drawn by that box does not matter?
 
Last edited:
I expect that a certification agency would look at your box as a single system, and view the PFC requirement as one item.
 
If you get a 13.5 (12V or 15V tweeked) >7A PSU that is certified, you can produce the negative supply with an inverting DC-DC converter.

Mike.
 
Status
Not open for further replies.

Similar threads

I
Need help adding a manual temp-on pushbutton switch to an alexa controlled relay.
Replies
6
Views
512
Les Jones
L
T
  • Question
Power problems
Replies
11
Views
3K
texas dave
T
  • Question
Bench Power Supply
2
Replies
20
Views
6K
Tony Stewart
F
Handy Bench Power Supply
Replies
8
Views
4K
schmitt trigger
S
  • Question
Adding an aux input to a microphone
Replies
1
Views
950
aliarifat794
A
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…