I tried to do somthing using HELP files and got this:
Initializes LCD at port with pin settings you specify: parameters RS, EN, WR, D7 .. D4 need to be a combination of values 0–7 (e.g. 3,6,0,7,2,1,4). Example: Lcd_Config(&PORTD, 0, 1, 7, 5, 4, 3, 2); so I changed the pins according to your LCD module connections and got Lcd_Config(&PORTB, 4, 5, 6, 3, 2, 1, 0); where WR bit is not mintioned I put 6. Then it gets stuck with Lcd_Init(); where I add (&PORTB) in the beraket, but again it gets stuck with ADC_Init(); I could not help it.
EDIT: I wrote this before seeing your post. Sooooory