Switch debouncer circuit in DIP package

[Boncuk]

Amendment:

I just checked the sites.

MME does not have their offers in English, Bilex has them. (Check the flags on top of their home page)

I was in slight error about the MME-price. 1squaredecimeter (100X100mm)= €29.50, so a standard board 160X100mm will cost €41.44.

100X100 is the minimum order size. No drill count and no extras for machining cuts, curves or round PCBs (round PCBs will be calculated as being a square). This applies to a double layer board with green solder stop mask and drill diameters starting at 0.3mm advancing to any size with a step size of 0.1mm. Finish is hot air levelling (HAL).

Bilex offers the same size board (160X100) with the same quality - including silksreen - for €34.60.

Internet address https://www.bilex-lp.com (capitals: BILEX-LP)

For your calculation convert 1€ approximately 1.5US$, so €34.60 equal US$51.90

Prices given apply to prototype boards. For small and big series prices contact: MME-PCB: Mrs. Margit Medinger, BILEX-PCB: Mr. Hristo Ginov.

Hans

 

[nickelflippr]

Thanks for the links and info Boncuk. Have seen some dip adapter boards recently on Ebay from Thailand, so thought they might be local there. A well known U.S. solar inverter manufacturer has their cast aluminum case design done in Thailand, so there must be some level of expertise there.

 

[Boncuk]

Thanks for the links and info Boncuk. Have seen some dip adapter boards recently on Ebay from Thailand, so thought they might be local there. A well known U.S. solar inverter manufacturer has their cast aluminum case design done in Thailand, so there must be some level of expertise there.

I know there are quite some foreign companies settled in Thailand. The biggest problem is the fact, that Thailand has no yellow pages. Searching for a specific part is therefore like stirring black coffee in absolute darkness.