I'm a newbie and don't deny it one bit. I'm going to study and learn ohms law, no problem there....and yea, I may be slightly rude but it's only b/c i came asking for help and caught a lot of slack.. and IMO not much help from the get-go.
From many of our prospectives you came here with a "secret intention" which is seen as suspicious and is treated as so by anyone who is familiar with how people approach topics here.
Then you expected that what you wanted could be done for an unreliably low price without full disclosure of the actual intention plus gave us many highly questionable explanations for what you where doing which didn't stand up to any solid scrutiny from those who also know automotive electronics and custom device design work. That just gave people here more reasons to not want to work with you or trust you.
First you pulled an attitude with me because I said no to doing your project over what is the realistic cost of custom work which anyone who does such work would see was as a reasonable and fair price. Then you insulted me about my skills and knowledge about what I know and have done in regards to custom vehicle electronics.
Now you have another thread here where information was given to you and you flat out admitted to not reading it or made any attempts to try and understand it and have now given others an attitude about it, again.
The pleases and sorries or where you grew up sob story doesn't help from my prospective. I went to school in a town for four years where I too had combined classes because my personal class had three people in it. I don't see how you could go to a small school like that and not have ever learned about social respect or manors.
Thats what all of this comes down to. Perhaps you should spend a few months learning the basics of social etiquette, manors, respect, honesty, and maturity then a come back here and try asking all of your questions again. I promise you that you will receive much more help, answers and a far nicer treatment from everyone here if you do!