CONFIG3H (OshonSoft P18 Simulator IDE)

[bcz]

I am new to OshonSoft (bought P18 Simulator IDE) and to the forum.
Vladimir sent me a short code to check if my programmer would work with his Simulator.
Everything works fine, but there is a discrepancy in the CONFIG3H byte, which I can't explain.
Please have a look at the screenshot attached.
Any comment is appreciated.
Robert

 

[DogFlu66]

This is the difference, "03" has the MCRL pin disabled (External Reset). In order to work with MCLR activated you have to place a pull-up resistor on that pin.