beakie
New Member
OK,
So I am using Eagle and for the first time I need to go beyond the restrictions placed upon the free version.
Any ideas on how to get around these size based limitations?
The board is essentially 3 boards with a few connections in between each... so I tried using header pins as a means of marking where I want the connections to be made and tried making 3 different boards and putting them together in paint.... but it all got a bit messy and very confusing.
Anyone got any ideas/advice (other than paying $125 for the non-profit version)? CHEERS!
So I am using Eagle and for the first time I need to go beyond the restrictions placed upon the free version.
Any ideas on how to get around these size based limitations?
The board is essentially 3 boards with a few connections in between each... so I tried using header pins as a means of marking where I want the connections to be made and tried making 3 different boards and putting them together in paint.... but it all got a bit messy and very confusing.
Anyone got any ideas/advice (other than paying $125 for the non-profit version)? CHEERS!